Operating instructions

GUIDE TO INSTALLATION AND OPERATION PRELIMINARY
4 | UVP-101i
2.2.3 Rear Panel Label
Connector labels have been shipped with the UVP-101i. These labels are to be installed on the rear panel of
the Quartet-M or Symphonie frame in order to identify the module’s external connectors.
Quartet-M Frame
To install the label on a Quartet-M frame, follow these steps while referring to Figure 2.2.
Figure 2.2 Rear panel label installation on Quartet-M frame
1. On Quartet’s rear panel, locate the appropriate connectors and remove the screws.
2. Carefully apply the label to the connectors.
3. Replace the screws making sure not to damage the label.
Symphonie Frame
To install the label on a Symphonie frame, follow these steps while referring to Figure 2.3.
1. On Symphonie’s rear panel, locate the
appropriate connectors.
2. Remove the rear label mounting screws from the
rear module.
3. Carefully apply the label to the connectors
making sure the label’s text is read from top to
bottom (refer to the Module Label Orientation
sticker on each side of the rear module bay).
4. Replace the screws, making sure not to damage
the label.
Figure 2.3 Rear panel label
installation on a Symphonie frame