Operating instructions

GUIDE TO INSTALLATION AND OPERATION PRELIMINARY
2 | UVP-101i
• 12-bit video signal processing and 20-bit audio embedding / de-embedding
• EDH monitoring and insertion
• SDI outputs with embedding of up to 2 AES groups (8 channels)
• Composite outputs
• True PAL decoding
2 Installation
2.1 Unpacking
Make sure the following items have been shipped with your UVP-101i. If any of the following items are
missing, contact your distributor or Miranda Technologies Inc.
• UVP-101i Universal Video Processor / Synchronizer
• Rear panel for frame
• Rear panel labels
• This manual
2.2 UVP-101i Mechanical Installation
The UVP-101i must be mounted within a Quartet-M or a Symphonie frame in order to provide power to the
module. The installation in a Symphonie frame also requires a Symphonie-R-M Rear Module. This section
describes how to install the UVP-101i in these frames. It is not necessary to switch off the power to these
frames when installing or removing the UVP-101i. Note: installation is also possible in Quartet, Quartet-C,
Solo, or Symphonie R-C frames, but the GPI / Delay connection will not be available in these cases. See
section 2.3.1 for more details.
2.2.1 Quartet-M Frame
To install this module into a Quartet-M frame follow these steps. For a closer look at module installation and
removal, refer to the Quartet Imaging Frame Guide to Installation and Operation.
1- Remove the frame’s front panel by rotating the thumb screws counter-clockwise. Pull on the handles.
2- Select an empty slot.
3- Carefully place the UVP-101i between a set of module guides and gently push the module towards the
rear of the frame until the module’s edge connector is secured to the backplane. Pull lightly on the
module, verifying that it does not move.
4- Replace the frame’s front panel. Make sure to rotate the thumb screws clockwise in order to secure it to
the chassis.
2.2.2 Symphonie Frame
Installing the Symphonie-R-M Rear Module
Before installing the UVP-101i module, you must first set and install the Symphonie-R-M Rear Module. To
install this module into the frame follow these steps. For a closer look at rear module installation and
removal, refer to the Symphonie Imaging Frame Guide to Installation and Operation.