Specifications

Guide to installation & Operation
UAP-711i/712i x 29
3.4.19 The setup menu {CONF}
Factory setups (STAL, MOD1, MOD2) reset all parameters to their original values programmed during
manufacturing, user setups (USR1, USR2) are available. They allow saving two board configurations
into a non-volatile memory. The table below lists the default values of the factory setups. The USR1 and
USR2 commands can be accessed by remote control.
Save setup procedure
• Press [+] or [-] to display {CONF},
• Press [SEL] displays LOAD, use [+] to display SAVE,
• Press [SEL] again displays USR1, use [+] or [-] to scroll through the available values: USR1, USR2.
• Press [SEL] to store the new setup, and to return to the previous menu
• Or press [ESC] to return to the previous menu without updating the parameters.
• To turn off the display, press [ESC].
Load setup procedure
The first setup STAL means stand alone mode. The MOD1 and MOD2 setup are intended for use with a
video processor: reference and tracking delay inputs are issued from the front panel Abus connector. In
MOD1 the digital audio signals come from the AES inputs, while in MOD2 the input selector is in the
Abus position and the module is ready to process the extracted audio. Once processed, signals are
sent to the video processor module for embedding. This modes suppose a flat cable link (ABUS)
between the UAP-712i and the video processor module.
• Press [+] or [-] to display {CONF},
• Press [SEL] displays LOAD,
• Press [SEL] again displays STAL, use [+] or [-] to scroll through the available values: STAL, USR1,
USR2, MOD1, MOD2.
• Press [SEL] to recall the new parameters, and to return to the previous menu
• Or press [ESC] to return to the previous menu without updating the parameters.
• To turn off the display, press [ESC].
STAL MOD1 MOD2
SEL ANLG AES Abus
FIX = 0 ms FIX = 0 ms FIX = 0 ms
TRAK = OFF TRAK = ON TRAK = ON
DLAY
LINK = OFF LINK = OFF LINK = OFF
I-1L > -1L I-1L > -1L I-1L > -1L
I-1R > -1R I-1R > -1R I-1R > -1R
I-2L > -2L I-2L > -2L I-2L > -2L
SWAP
I-2R > -2R I-2R > -2R I-2R > -2R
LVL 0 dB 0 dB 0 dB
PHSE NORM NORM NORM
MIX OFF OFF OFF
TEST OFF OFF OFF
OLVL 0 dB 0 dB 0 dB
MUTE OFF OFF OFF
MNTR ENAB = OFF ENAB = OFF ENAB = OFF
ALRM ON ON ON
REF = ”BNC”, REF = Abus REF = ABus ABUS
TRAK = RJ45 TRAK = Abus TRAK = ABus
AES PRO PRO PRO
ORIG 0000 0000 0000
DEST 0000 0000 0000
CHST AUTO AUTO AUTO
OSR = 48k OSR = 48k OSR = 48k SRWL
OWL = 24bt OWL = 20bt OWL = 20bt