Specifications

Guide to installation & Operation
UAP-711i/712i x 25
3.4.12 The alarm deactivation menu {ALRM}
Follow these steps to disable or enable alarm of a digital channel. Once disabled, alarms are not
transmitted to iControl and the GPI outputs are inactive. These parameters can be accessed by remote
control.
Procedure
• Press [+] or [-] to display {ALRM},
• Press [SEL] to display 1&2, use [+] or [-] to scroll through the available channels 1&2, 1, 2 (UAP-712i
only).
• Press [SEL] validates the channel and displays the current mode, use [+] or [-] to scroll through the
available modes OFF or ON.
• Press [SEL] to store the new parameter, and to return to the previous menu
• Or press [ESC] to return to the previous menu without updating the parameter.
• To turn off the display, press [ESC].
3.4.13 The video synchronizer interface menu {ABUS}
When a UAP-712i is used with a video processor the front panel ABUS connector allows direct
connections between the two modules for synchronization signal, audio digital inputs/outputs and a
delay tracking signal.
Example: the UAP-712i converts the analog audio signals, process and send them to a DVP-101i for
embedding. This is done by selecting the Abus source for reference and Abus source for the tracking
delay.
These parameters can be accessed by remote control.
Reference source procedure
To insure synchronization between the two modules the UAP-712i must be referenced to a 27 MHz
generated by the video processor, it can be done with the REF menu:
• Press [+] or [-] to display {ABUS},
• Press [SEL] to display REF,
• Press [SEL] again displays the current selection “BNC” or ABus, use [+] or [-] to change the source
selection. BNC will be displayed only if there is no reference connected at the REF.IN BNC connector
or at the AES SUBD. If a valid reference is detected the display will show WORD, AES, PAL or
NTSC, relying upon the signal standard.
• Press [SEL] to store the new parameter, and to return to the {ABUS} menu
• Or press [ESC] to return to the {ABUS} menu without updating the parameter.
Tracking delay source procedure
The TRAK menu allows the source selection for the tracking delay signal: either on the rear panel RJ45
or on the front panel ABUS connector:
• Press [+] or [-] to display {ABUS},
• Press [SEL] to display REF, and use [+] twice to display TRAK,
• Press [SEL] again displays the current selection RJ45 or ABus, use [+] or [-] to select the source.
• Press [SEL] to store the new parameter, and to return to the {ABUS} menu
• Or press [ESC] to return to the {ABUS} menu without updating the parameter.