Specifications

Guide to installation & Operation
UAP-711i/712i x 19
3.4.1 The input status menu {STAT}
This menu visualizes the status of the analog, digital and reference inputs. It also indicates the RMS
value of the analog inputs and outputs associated to the digital 0 dBFS (Full Scale). These parameters
can be read by remote control.
Procedure for analog inputs status
The display indicates presence of audio signal at the left, right or both inputs (NONE, L ok, R ok, LR.
ok).
• Press [+] or [-] displays {STAT},
• Press [SEL] displays AIN1, use [+] or [-] to select AIN1, AIN2 (UAP-712i only),
• Press [SEL] validates the channel and displays the analog input status.
• Press [SEL] or [ESC] to return to the previous menu.
Procedure for AES inputs status
The SIG. parameter indicates presence of audio signal at the left, right or both inputs (NONE, L ok, R
ok, LR.ok). ISR stands for input sample rate, it displays the measured value in kHz with a three digits
precision. IWL means input word length: for even coded lengths, the display reflects the contents of the
channel status bits; rarely found, the odd values are rounded to the inferior even one (ex: 19 bits
becomes 18). This information may be used to adjust the output word length. If nothing is coded ??bt is
displayed. EMPH parameter is an image of the emphasis channel status bits, if « no emphasis » is
coded NONE is displayed, if nothing is coded ??EM is displayed, 5015 or J17 will be displayed when
coded.
• Press [+] or [-] displays {STAT},
• Press [SEL] displays AIN1, use [+] or [-] to select DIN1, DIN2 (UAP-712i only),
• Press [SEL] validates the channel and displays SIG., use [+] or [-] to scroll through the available
parameters SIG., ISR, IWL, MODE, EMPH, ORIG, DEST.
• Press [SEL] displays the current parameter value.
• Press [SEL] or [ESC] to return to the previous menu
• Use [+] or [-] to scroll through the available parameters SIG., ISR, IWL, MODE, EMPH, ORIG, DEST,
or press [ESC] to return to the previous menu.
• To turn off the display, press [ESC].
Procedure for reference input status
In stand alone mode the display indicates the reference type seen by the module (PAL, NTSC, AES,
WORD), if there is no valid signal at the inputs NONE is displayed. An AES3 signal connected at the D-
Sub connector has a higher priority than any signal at the BNC. If ABus input is selected as reference
source (video synchronizer menu), the REF led in green indicates the validity of the 27 MHz signal
delivered by the video module.
• Press [+] or [-] displays {REF},
• Press [SEL] displays the current reference, NONE, ABus, PAL, NTSC, AES, WORD.
• Press [SEL] or [ESC] to return to the previous menu.
Procedure for 0dBFS value
The display indicates the RMS value of the input or output sine wave associated to the digital 0 dBFS
with all level adjustments set to 0 dB. The available values are:+24, +22, +21, +20, +18, +16, +15 dBu.
• Press [+] or [-] displays {STAT},
• Press [SEL] displays REF, use [+] or [-] to select dBFS,
• Press on [SEL] displays the current parameter value in dBu,
• Press [SEL] or [ESC] to return to the previous menu.