Specifications

Guide to installation & Operation
UAP-711i/712i x 13
3 Operation
3.1 UAP-711i or UAP-712i user interface
The Figure below illustrates the UAP-711i or UAP-712i user interface situated at the front end of the
card. For information on these controls, refer to the rest of this section.
UAP-712i
-
ABUS
TOP VIEW
YELLOW
INPUT 2
LOCK
+
SELECT
RED
BICOLOR
UNIVERSAL AUDIO PROCESSOR
ESC.
INPUT 1
FRONT VIEW
GREEN
RL TEST LOCK RL TEST REF
UAP-711i
UAP-712i
Figure 11: UAP-711i or UAP-712i user interface
Status leds
LOCK (bi-color)
Green: AES signal detected.
Orange: non-audio signal detected.
Red: indicates parity error, coding error or a no lock condition on
AES input.
L (1 green + 1 red)
The two Leds are assigned to channel 1 left after the ANLG, DIGT or
Abus input selector.
Green: lights when a signal is present (threshold –60 dBFS).
Red: indicates overload or an absence of signal for 15 seconds.
R (1 green + 1 red)
These two Leds correspond to channel 1 right.
INPUT 1
TEST (yellow)
EBU tone or mute selected.
LOCK (bi-color)
INPUT 2
L (1 green + 1 red)
R (1 green + 1 red)
TEST (yellow)
These Leds correspond to input 2.
REF (Bi-color)
Green, orange or red: indicates the lock/no-lock condition of the AES
outputs (refer to synchronization paragraph 2.5.3)
Front panel pushbuttons
[SEL]
Activates the displayed parameter
[-]
Decreases value of selected parameter
[+]
Increases value of selected parameter
[ESC]
Returns to previous parameter
Main menu parameters
Input status
Input Selector
Delay
Channel swapping
Input level adjustment
Phase Inversion
Mixing
Test (tone generator)
Output level adjustment
Mute (AES silence)
Monitoring functions
Alarm deactivation
ABUS (interface with video synchronizer)
AES channel status source
AES mode (Pro. or Consumer)
AES Origin and destination message
AES output format
Factory configurations