Setup guide
Table Of Contents
- Introduction to iControl Edge
- System Requirements
- Installation and Setup
- Key Concepts
- Task 1: Preparing to Install an iControl Edge System
- Task 2: Installing the iControl Application Server
- Task 3: Preparing a PC for Configuring the Application Server
- Task 4: Configuring the Application Server
- Task 5: Installing & Configuring EdgeVision Devices
- Task 6: Installing & Configuring Densité Systems
- Task 7: Installing & Configuring GC-100 Network Adapters
- Task 8: Installing Set-Top Boxes
- Task 9: Installing & Configuring Allégro Systems
- Task 10: Verification & Readiness Check
- Task 11: Managing the iControl Edge Configuration Files
- Task 12: Uploading and Applying iControl Edge Configuration Files
- Key Concepts
- Troubleshooting
- Installing PuTTY
- Using WinSCP
- Contact Us!
iControl Edge
Installation and Setup Guide
87
•PDUs
•Set-top boxes
Devices worksheet (part 1)
Devices worksheet (part 2)
This worksheet also includes a section where virtual devices are defined. A virtual device is
an abstract concept, that associates a physical Densité card to a cycler profile.
The last section at the bottom of this worksheet is the Cycler section where the necessary cycler
profiles are configured.
Table 3-3, below, describes the worksheet contents (column headings listed alphabetically):