Setup guide
Table Of Contents
- Introduction to iControl Edge
- System Requirements
- Installation and Setup
- Key Concepts
- Task 1: Preparing to Install an iControl Edge System
- Task 2: Installing the iControl Application Server
- Task 3: Preparing a PC for Configuring the Application Server
- Task 4: Configuring the Application Server
- Task 5: Installing & Configuring EdgeVision Devices
- Task 6: Installing & Configuring Densité Systems
- Task 7: Installing & Configuring GC-100 Network Adapters
- Task 8: Installing Set-Top Boxes
- Task 9: Installing & Configuring Allégro Systems
- Task 10: Verification & Readiness Check
- Task 11: Managing the iControl Edge Configuration Files
- Task 12: Uploading and Applying iControl Edge Configuration Files
- Key Concepts
- Troubleshooting
- Installing PuTTY
- Using WinSCP
- Contact Us!

iControl Edge
Installation and Setup Guide
85
2. Add rows until there are enough to describe each location in your iControl Edge
configuration.
3. For each row, specify an ID, a short name, a long name, the Application Server’s IP address,
its host name and the name of the corresponding spreadsheet file.
Version Worksheet
The iControl Edge configuration spreadsheets included with your initial purchase of an iControl
Edge Application Server match the current version of the iControl Edge package. The set of
spreadsheets provided with the next software release could have a different structure.
However, when upgrading your iControl Edge system, you do not need to start over, and port
all your existing data to the new spreadsheets. The Model attribute ensures that legacy
spreadsheets can still be parsed with a new version of the package.
When you are ready to use the new features introduced with the most recent version of the
package, then all you need to do is to add the necessary columns and rows to your existing
spreadsheets, and populate them based on your actual system configuration. Once you have
completed adding the new data, you must update the Version worksheet accordingly.
LONG NAME The full name of the location. Will be displayed above the Detailed Signal Analysis area, and as
a tooltip.
Optional.
IP IP address of the Application Server at this location.
Mandatory.
HOSTNAME Host name of the Application Server at this location. Must match the name specified under
HOSTNAME for the Application Server, in the Devices worksheet for this location.
Case sensitive.
Mandatory.
SPREADSHEET Name of the file that defines the monitoring devices available at this location.
The names of the Devices spreadsheet files should be unique across the entire iControl Edge
configuration (e.g.
EDGE1.xls, EDGE2.xls, etc.).
Mandatory.
1. Rows you wish to leave empty must include the two asterisks in this column.
Note: The short names appear on the Location buttons. On a typical system, the
Location buttons can fit approximately 10 characters (or up to 16 characters, in the
iControl Edge Web pages designed for a 1280 × 1024 display resolution). Longer
names may appear truncated.
(
Conti nued
)
Column Description