Setup guide
Table Of Contents
- Introduction to iControl Edge
- System Requirements
- Installation and Setup
- Key Concepts
- Task 1: Preparing to Install an iControl Edge System
- Task 2: Installing the iControl Application Server
- Task 3: Preparing a PC for Configuring the Application Server
- Task 4: Configuring the Application Server
- Task 5: Installing & Configuring EdgeVision Devices
- Task 6: Installing & Configuring Densité Systems
- Task 7: Installing & Configuring GC-100 Network Adapters
- Task 8: Installing Set-Top Boxes
- Task 9: Installing & Configuring Allégro Systems
- Task 10: Verification & Readiness Check
- Task 11: Managing the iControl Edge Configuration Files
- Task 12: Uploading and Applying iControl Edge Configuration Files
- Key Concepts
- Troubleshooting
- Installing PuTTY
- Using WinSCP
- Contact Us!
iControl Edge
Installation and Setup Guide
83
4. Select the spreadsheet files (typically Locations.xls and EDGE.xls), and drag them to a
convenient location on your PC or laptop.
A confirmation window may appear.
5. Click Copy to continue.
6. When you are done, close the main WinSCP window.
7. If prompted, click OK to close the application.
You have successfully downloaded a copy of the configuration spreadsheets
(see "Modifying the iControl Edge Configuration Spreadsheets", on page 83 for information
on how to edit these files).
Modifying the iControl Edge Configuration Spreadsheets
You can edit the configuration spreadsheets on any client PC or laptop with the Microsoft®
Excel® spreadsheet software installed. Once the files have been edited, you will transfer them
back to the Application Server as described in "Uploading the iControl Edge Configuration
Spreadsheets", on page 110.
IMPORTANT: iControl Edge is Case-Sensitive to Data Entered in Spreadsheets.
Make sure all data entered into both spreadsheets
Note: Before editing a configuration spreadsheet, make a backup copy that can be
used to restore the system to its previous state.