Setup guide
Table Of Contents
- Introduction to iControl Edge
- System Requirements
- Installation and Setup
- Key Concepts
- Task 1: Preparing to Install an iControl Edge System
- Task 2: Installing the iControl Application Server
- Task 3: Preparing a PC for Configuring the Application Server
- Task 4: Configuring the Application Server
- Task 5: Installing & Configuring EdgeVision Devices
- Task 6: Installing & Configuring Densité Systems
- Task 7: Installing & Configuring GC-100 Network Adapters
- Task 8: Installing Set-Top Boxes
- Task 9: Installing & Configuring Allégro Systems
- Task 10: Verification & Readiness Check
- Task 11: Managing the iControl Edge Configuration Files
- Task 12: Uploading and Applying iControl Edge Configuration Files
- Key Concepts
- Troubleshooting
- Installing PuTTY
- Using WinSCP
- Contact Us!
Installation and Setup
Capturing IR Codes from Remote Control Units
80
4. Select the configuration file template (setTopModelTEMPLATE.conf), and then drag it to a
convenient location on your PC.
A confirmation window may appear.
5. Click Copy to continue.
6. Once the download has completed, close the main WinSCP window.
If prompted, click OK to close the application.
You have successfully downloaded a copy of the configuration file template. You can now
proceed with populating this file with the required information, as described below
(see "Capturing IR Codes from Remote Control Units", on page 80).
Capturing IR Codes from Remote Control Units
To capture the information required to recreate the IR signals that correspond to your specific
set-top box models, you will need to use Global Caché - IR Learner Utility with the GC-IRL IR
Learner serial device from Global Caché (see
http://www.globalcache.com/products/ir‐
index.html
).
Note: If you have more than one custom file to create, you may want to set aside a
read-only copy of the template file on your hard drive to avoid having to download
the clean template from the server again.