Setup guide

iControl Edge
Installation and Setup Guide
75
6. Type (or copy and paste) the following into the new file:
•
v=0
• c=INIP4127.0.0.1
• m=video46010RTP/AVP96
• a=rtpmap:96MVC3/90000
• a=control:trackID=6
• m=audio46012RTP/AVP1
• a=rtpmap:1MAC2/44100
• a=control:trackID=7
7. Change the port number in the third line (46010 in the sample above) to a port number that
is unique to this Allégro.
8. Change the port number in the sixth line (
46012 in the sample above) to a port number that
is unique to this Allégro—usually the video component port number plus two; this is the
port that will be used for the audio component of the streaming relay.
9. Save and close the file.
10. Repeat step 4 to step 9 for each Allégro in your configuration.
Next, you must configure each Allégro so that it streams to the Application Server.
11. In your Web browser’s address bar, type the Allégro’s IP address and specify port 8080.
(e.g.
http://10.44.34.25:8080).
12. Under Streaming Encoder, click Configuration.
Note: The file name must match one of the names specified in the Devices tab of the
configuration spreadsheet (see "Devices Worksheet", on page 86). For example, if this
streaming relay corresponds to the device Allegro1 in the spreadsheet, the file should
be named
ALLEGRO1.sdp.
Note: This is the port that will be used for the video component of the streaming
relay.
Note: The port numbers for the video and audio streaming components must be
unique for each Allégro. As you create additional SDP files, increment the previously
assigned port number by 4. For example, if the port numbers used in
ALLEGRO1.sdp
are
46010 and 46012, then the port numbers used in ALLEGRO2.sdp should be 46014
and
46016, and so on.