Setup guide
Table Of Contents
- Introduction to iControl Edge
- System Requirements
- Installation and Setup
- Key Concepts
- Task 1: Preparing to Install an iControl Edge System
- Task 2: Installing the iControl Application Server
- Task 3: Preparing a PC for Configuring the Application Server
- Task 4: Configuring the Application Server
- Task 5: Installing & Configuring EdgeVision Devices
- Task 6: Installing & Configuring Densité Systems
- Task 7: Installing & Configuring GC-100 Network Adapters
- Task 8: Installing Set-Top Boxes
- Task 9: Installing & Configuring Allégro Systems
- Task 10: Verification & Readiness Check
- Task 11: Managing the iControl Edge Configuration Files
- Task 12: Uploading and Applying iControl Edge Configuration Files
- Key Concepts
- Troubleshooting
- Installing PuTTY
- Using WinSCP
- Contact Us!
iControl Edge
Installation and Setup Guide
73
18. Type the new IP address, network mask, and default gateway address in the corresponding
boxes, and then click Apply.
Configuring Allégro Streaming Relays
In an iControl Edge configuration, operators typically monitor audio/video streams from
several remote locations at once. Having each remote Allégro send a stream to multiple
operators over a WAN can result in performance problems. The recommended alternative is
to have each remote Allégro send its stream to the Application Server, and then have these
streams relayed over the local network to the operators’ client workstations.
On the Application Server, for each Allégro in the configuration, you will need to create a file
that provides some important parameters.
To configure streaming relays
1. Launch WinSCP. If you do not have WinSCP installed on your PC or laptop, see "Installing
WinSCP", on page 125.
2. Log on to the Application Server (see "Logging on to an Application Server from WinSCP",
on page 129).
The main WinSCP window opens, showing the files on your PC in the left panel, and the files
on the Application Server in the right panel.
Note: Only user root is allowed to add or modify files in the specific directory where
the streaming relay configuration files must be located. Be sure to log on as user
root
(default password is
icontrol).