Setup guide
Table Of Contents
- Introduction to iControl Edge
- System Requirements
- Installation and Setup
- Key Concepts
- Task 1: Preparing to Install an iControl Edge System
- Task 2: Installing the iControl Application Server
- Task 3: Preparing a PC for Configuring the Application Server
- Task 4: Configuring the Application Server
- Task 5: Installing & Configuring EdgeVision Devices
- Task 6: Installing & Configuring Densité Systems
- Task 7: Installing & Configuring GC-100 Network Adapters
- Task 8: Installing Set-Top Boxes
- Task 9: Installing & Configuring Allégro Systems
- Task 10: Verification & Readiness Check
- Task 11: Managing the iControl Edge Configuration Files
- Task 12: Uploading and Applying iControl Edge Configuration Files
- Key Concepts
- Troubleshooting
- Installing PuTTY
- Using WinSCP
- Contact Us!
iControl Edge
Installation and Setup Guide
71
Streaming Encoder Configuration page (Video/Audio)
9. In the Video section, make sure Enabled is set to Yes.
10. In the Video section, select the encoding, frame rate, and video quality as follows:
11. In the Audio section, make sure the Enabled setting is
Yes.
12. In the Audio section, set Encoding to
MAC2‐44100samp./sec,16bit,stereo.
13. Click Apply.
14. Click Compression in the navigation bar near the top of the Streaming Encoder
Configuration page.
Parameter Recommended value
Encoding MVC3 -- 640 × 480
Frame rate 15 (or less)
Video quality 9.0