Setup guide
Table Of Contents
- Introduction to iControl Edge
- System Requirements
- Installation and Setup
- Key Concepts
- Task 1: Preparing to Install an iControl Edge System
- Task 2: Installing the iControl Application Server
- Task 3: Preparing a PC for Configuring the Application Server
- Task 4: Configuring the Application Server
- Task 5: Installing & Configuring EdgeVision Devices
- Task 6: Installing & Configuring Densité Systems
- Task 7: Installing & Configuring GC-100 Network Adapters
- Task 8: Installing Set-Top Boxes
- Task 9: Installing & Configuring Allégro Systems
- Task 10: Verification & Readiness Check
- Task 11: Managing the iControl Edge Configuration Files
- Task 12: Uploading and Applying iControl Edge Configuration Files
- Key Concepts
- Troubleshooting
- Installing PuTTY
- Using WinSCP
- Contact Us!
Installation and Setup
Configuring the Allégro
70
5. Type the new IP address and host name of the Application Server, and then click Add
Location.
6. Click Configuration under the System heading in the navigation pane, and then click Edit
GSM Locations in the main pane.
The GSM Location page appears.
7. Type the new IP address and host name of the Application Server, and then click Add GSM.
8. Click Configuration under the Streaming Encoder heading in the left pane.
The Streaming Encoder Configuration page appears.