Setup guide
Table Of Contents
- Introduction to iControl Edge
- System Requirements
- Installation and Setup
- Key Concepts
- Task 1: Preparing to Install an iControl Edge System
- Task 2: Installing the iControl Application Server
- Task 3: Preparing a PC for Configuring the Application Server
- Task 4: Configuring the Application Server
- Task 5: Installing & Configuring EdgeVision Devices
- Task 6: Installing & Configuring Densité Systems
- Task 7: Installing & Configuring GC-100 Network Adapters
- Task 8: Installing Set-Top Boxes
- Task 9: Installing & Configuring Allégro Systems
- Task 10: Verification & Readiness Check
- Task 11: Managing the iControl Edge Configuration Files
- Task 12: Uploading and Applying iControl Edge Configuration Files
- Key Concepts
- Troubleshooting
- Installing PuTTY
- Using WinSCP
- Contact Us!
Installation and Setup
Accessing the Allégro
68
Accessing the Allégro
The Allégro has a built-in Web-based management utility. This utility is available as soon as
the system is powered up, and can be used to configure the system using a Web browser on
any PC or laptop, provided the PC or laptop can reach the Allégro’s IP address.
To access the Allégro system
1. Configure your Client PC or laptop with an IP address in the same range as the IP address of
the Allégro (see "Preparing a PC for Configuring the Application Server", on page 22).
2. Open a Web browser and type the Allégro’s default IP address (see "Network Configuration",
on page 11), specifying a connection on port 8080.
http://10.3.0.7:8080/
The Allégro Startup Page appears.
Configuring the Allégro
To configure the Allégro system
1. Click Administration page on the Allégro Startup page.
2. When prompted, type
admin in the User Name box, type 16streams in the Password box,
and then press
Enter
.
The System Status page appears.