Setup guide

Installation and Setup
Installing & Configuring GC-100 Network Adapters
64
The Profile copy for card window appears, with the current card identified under Copy
profile from. All other cards of the same type are listed under Copy profile to.
14. For each card to which you wish to copy the current profile, select the corresponding check
box in the Select column.
15. Select Select All at the top of the column to select all the available cards.
16. Click Copy.
A successful copy is indicated for each card by the appearance of the word
Succeeded in the
Transfer Status column.
17. Click Exit to close the Profile Copy for Card window.
18. Close iControl Navigator.
This will also close any control panels that were left open, and other secondary windows.
Task 7: Installing & Configuring GC-100 Network Adapters
Install and configure your GC-100 units to make them available on your local network. You
also need to configure the appropriate number of IR or Sensor connectors on each unit as
IR output. Refer to the Global Caché GC-100-12 Network Adapter Quick Start Guide
(see "Reference Material", on page 3 for details).
Configuring the GC-100 IR Service
Once your GC-100 units are connected to your local network you must enable the GC-100
IR service on the Application Server.
To enable the GC-100 Service
1. Log on to Webmin (see "Logging on to Webmin", on page 30).
2. Click Miranda iControl Management Tool.
The Miranda Setup page appears.
3. Click the iControl logo next to iControl services monitoring and configuration tool.
The Miranda Monitoring page appears.
4. Find the row corresponding to the GC-100 IR service.
Note: The copy profile operation is prohibited when a target card does not have the
same firmware version as the source card. In such cases, the designation
N/A will
appear on a yellow background in the Transfer status column.
IMPORTANT: Perform this task only if you are NOT installing an EdgeVision for the purposes of
sending IR commands to STBs.