Setup guide
Table Of Contents
- Introduction to iControl Edge
- System Requirements
- Installation and Setup
- Key Concepts
- Task 1: Preparing to Install an iControl Edge System
- Task 2: Installing the iControl Application Server
- Task 3: Preparing a PC for Configuring the Application Server
- Task 4: Configuring the Application Server
- Task 5: Installing & Configuring EdgeVision Devices
- Task 6: Installing & Configuring Densité Systems
- Task 7: Installing & Configuring GC-100 Network Adapters
- Task 8: Installing Set-Top Boxes
- Task 9: Installing & Configuring Allégro Systems
- Task 10: Verification & Readiness Check
- Task 11: Managing the iControl Edge Configuration Files
- Task 12: Uploading and Applying iControl Edge Configuration Files
- Key Concepts
- Troubleshooting
- Installing PuTTY
- Using WinSCP
- Contact Us!
iControl Edge
Installation and Setup Guide
63
Alarm configuration example
7. Once all relevant alarms are enabled and configured for this card, click Copy to other cards.
The Copy to other cards window appears, displaying a list of all cards of the same type.
8. For each card to which you wish to copy the current alarm configuration, select the
corresponding check box.
9. Select the All check box at the top of the column to select all the available cards.
10. Select the All check box again to remove all check marks.
11. Click Copy.
A successful copy is indicated for each card by the appearance of the word
Succeeded in the
Transfer status column.
12. Click Close to close the Copy to other cards window.
13. Click Profiles at the bottom left of the control panel.