Setup guide
Table Of Contents
- Introduction to iControl Edge
- System Requirements
- Installation and Setup
- Key Concepts
- Task 1: Preparing to Install an iControl Edge System
- Task 2: Installing the iControl Application Server
- Task 3: Preparing a PC for Configuring the Application Server
- Task 4: Configuring the Application Server
- Task 5: Installing & Configuring EdgeVision Devices
- Task 6: Installing & Configuring Densité Systems
- Task 7: Installing & Configuring GC-100 Network Adapters
- Task 8: Installing Set-Top Boxes
- Task 9: Installing & Configuring Allégro Systems
- Task 10: Verification & Readiness Check
- Task 11: Managing the iControl Edge Configuration Files
- Task 12: Uploading and Applying iControl Edge Configuration Files
- Key Concepts
- Troubleshooting
- Installing PuTTY
- Using WinSCP
- Contact Us!
Installation and Setup
Configuring Alarm Settings
62
Example of a control panel showing enabled video black alarm settings
4. Click Alarm config.
The Alarm Configuration window for this Densité probe opens.
5. In the Log events column, clear the first check box to disable all event logging for this
probe.
This will avoid filling the event log with irrelevant entries.
6. For each alarm you enabled for this card, set the appropriate overall and GSM contribution.