Setup guide
Table Of Contents
- Introduction to iControl Edge
- System Requirements
- Installation and Setup
- Key Concepts
- Task 1: Preparing to Install an iControl Edge System
- Task 2: Installing the iControl Application Server
- Task 3: Preparing a PC for Configuring the Application Server
- Task 4: Configuring the Application Server
- Task 5: Installing & Configuring EdgeVision Devices
- Task 6: Installing & Configuring Densité Systems
- Task 7: Installing & Configuring GC-100 Network Adapters
- Task 8: Installing Set-Top Boxes
- Task 9: Installing & Configuring Allégro Systems
- Task 10: Verification & Readiness Check
- Task 11: Managing the iControl Edge Configuration Files
- Task 12: Uploading and Applying iControl Edge Configuration Files
- Key Concepts
- Troubleshooting
- Installing PuTTY
- Using WinSCP
- Contact Us!
iControl Edge
Installation and Setup Guide
61
Example of a control panel showing RALM settings
Configuring Alarm Settings
To configure relevant alarms on a Densité probe
1. In iControl Navigator, select the Densité card you wish to configure.
2. On the View menu, click Show control panel, to open the card’s control panel.
3. Enable and configure all relevant alarms (e.g. video black and freeze, audio silence and
overload).
Note: Make sure to set the alarm duration to the lowest value (typically 1 second)
and the number of occurrences to 1.