Setup guide
Table Of Contents
- Introduction to iControl Edge
- System Requirements
- Installation and Setup
- Key Concepts
- Task 1: Preparing to Install an iControl Edge System
- Task 2: Installing the iControl Application Server
- Task 3: Preparing a PC for Configuring the Application Server
- Task 4: Configuring the Application Server
- Task 5: Installing & Configuring EdgeVision Devices
- Task 6: Installing & Configuring Densité Systems
- Task 7: Installing & Configuring GC-100 Network Adapters
- Task 8: Installing Set-Top Boxes
- Task 9: Installing & Configuring Allégro Systems
- Task 10: Verification & Readiness Check
- Task 11: Managing the iControl Edge Configuration Files
- Task 12: Uploading and Applying iControl Edge Configuration Files
- Key Concepts
- Troubleshooting
- Installing PuTTY
- Using WinSCP
- Contact Us!
Installation and Setup
Enabling Audio Level Meters
60
Example of a control panel showing Thumbnail settings
Enabling Audio Level Meters
The procedure below is an example showing how to enable the appropriate audio level meter
on HCP-1801 cards. Some steps may vary, depending on your actual card model. Refer to the
documentation that shipped with the card you wish to configure (see "Reference Material",
on page 3).
To enable audio level meters
1. In iControl Navigator, select the Densité card you wish to configure.
2. On the View menu, click Show control panel, to open the card’s control panel.
3. Click the control panel’s RALM tab.
4. Under RALM remote control, select the AES1 check box.
5. Select Fast from the Speed list.