Setup guide
Table Of Contents
- Introduction to iControl Edge
- System Requirements
- Installation and Setup
- Key Concepts
- Task 1: Preparing to Install an iControl Edge System
- Task 2: Installing the iControl Application Server
- Task 3: Preparing a PC for Configuring the Application Server
- Task 4: Configuring the Application Server
- Task 5: Installing & Configuring EdgeVision Devices
- Task 6: Installing & Configuring Densité Systems
- Task 7: Installing & Configuring GC-100 Network Adapters
- Task 8: Installing Set-Top Boxes
- Task 9: Installing & Configuring Allégro Systems
- Task 10: Verification & Readiness Check
- Task 11: Managing the iControl Edge Configuration Files
- Task 12: Uploading and Applying iControl Edge Configuration Files
- Key Concepts
- Troubleshooting
- Installing PuTTY
- Using WinSCP
- Contact Us!
iControl Edge
Installation and Setup Guide
59
The new Densité Communicator will be started and added to the list. The Application
Server will query the corresponding Densité frame, and any devices (e.g. cards) it discovers
will be displayed in the iControl Navigator window.
6. Repeat this procedure until you have added Communicator services for every Densité
frame in your iControl Edge configuration.
Configuring the Probing Features
For each Densité module in your iControl Edge configuration, you need to enable thumbnail
streaming and/or audio level meters. You must also configure the appropriate video and audio
alarms for your monitoring purposes, and disable all logging to avoid filling the system logs
with irrelevant entries.
Enabling Thumbnail Streaming
To enable thumbnail streaming on a video probe
1. In iControl Navigator, select the Densité card you wish to configure.
2. On the View menu, click Show control panel, to open the card’s control panel.
3. Click the control panel’s Thumbnail tab.
4. Under Enable, click Video.
5. Under Size, click Large.
6. Select Fast from the Rate list.
See also
For more information about Densité Communicator services (also called Densité
Frame services), see the Configuring Devices & Services chapter in the iControl User
Guide (see "Reference Material", on page 3).