Setup guide
Table Of Contents
- Introduction to iControl Edge
- System Requirements
- Installation and Setup
- Key Concepts
- Task 1: Preparing to Install an iControl Edge System
- Task 2: Installing the iControl Application Server
- Task 3: Preparing a PC for Configuring the Application Server
- Task 4: Configuring the Application Server
- Task 5: Installing & Configuring EdgeVision Devices
- Task 6: Installing & Configuring Densité Systems
- Task 7: Installing & Configuring GC-100 Network Adapters
- Task 8: Installing Set-Top Boxes
- Task 9: Installing & Configuring Allégro Systems
- Task 10: Verification & Readiness Check
- Task 11: Managing the iControl Edge Configuration Files
- Task 12: Uploading and Applying iControl Edge Configuration Files
- Key Concepts
- Troubleshooting
- Installing PuTTY
- Using WinSCP
- Contact Us!
iControl Edge
Installation and Setup Guide
57
Miranda Monitoring page (Densité Manager Service circled)
4. Find the row corresponding to the Densité Manager service.
5. In the Start/Stop/Restart column, select the Auto check box, click the Start option button,
and then click Apply at the bottom of the page.
Adding Densité Communicator Services
To add a Densité Communicator service
1. Open iControl Navigator.
2. Double-click DensiteManager in the logical view.
Note: If you need to increase the number of Densité Managers, select the
appropriate number for your purposes from the list at the bottom of the page, before
clicking the Apply button next to it.