Setup guide
Table Of Contents
- Introduction to iControl Edge
- System Requirements
- Installation and Setup
- Key Concepts
- Task 1: Preparing to Install an iControl Edge System
- Task 2: Installing the iControl Application Server
- Task 3: Preparing a PC for Configuring the Application Server
- Task 4: Configuring the Application Server
- Task 5: Installing & Configuring EdgeVision Devices
- Task 6: Installing & Configuring Densité Systems
- Task 7: Installing & Configuring GC-100 Network Adapters
- Task 8: Installing Set-Top Boxes
- Task 9: Installing & Configuring Allégro Systems
- Task 10: Verification & Readiness Check
- Task 11: Managing the iControl Edge Configuration Files
- Task 12: Uploading and Applying iControl Edge Configuration Files
- Key Concepts
- Troubleshooting
- Installing PuTTY
- Using WinSCP
- Contact Us!
iControl Edge
Installation and Setup Guide
55
Installing Densité Frames
To install a Densité frame
1. Install the housing frame directly into a standard 19in rack using 4 standard rack-mounting
screws.
2. Fit all received Densité series cards and rear panels into the frame, referring to the Densité
Housing Frame Guide to Installation and Operation for detailed instructions (see "Reference
Material", on page 3).
3. Make the appropriate video, audio and network connections, referring to the Densité
CPU-ETH2 Enhanced Ethernet Controller Card Guide to Installation and Operation, to learn
how to connect your Densité system to the network, and to the documentation included
with each card (see "Reference Material", on page 3).
4. Connect the supplied AC power cord to the rear-panel AC receptacle, and secure it with the
retainer clip attached to the receptacle.
5. Plug the power cord into an AC outlet to turn the unit on.
Configuring Densité Services
Before you can begin operations, you must configure Densité Manager and Densité
Communicator services to make your Densité frames and the associated Densité modules
available on your local network. Specifically, you may have to:
• enable at least one Densité Manager service on the Application Server
• access the appropriate Densité Manager control panel and add a Densité Communicator
service for each Densité frame included in your system
• access your Densité card’s control panels to enable thumbnails and audio level meters, and
to configure video and audio alarms.
Enabling Densité Manager Services
To enable a Densité Manager Service
1. Log on to Webmin (see "Logging on to Webmin", on page 30).
2. Click Miranda iControl Management Tool.