Setup guide
Table Of Contents
- Introduction to iControl Edge
- System Requirements
- Installation and Setup
- Key Concepts
- Task 1: Preparing to Install an iControl Edge System
- Task 2: Installing the iControl Application Server
- Task 3: Preparing a PC for Configuring the Application Server
- Task 4: Configuring the Application Server
- Task 5: Installing & Configuring EdgeVision Devices
- Task 6: Installing & Configuring Densité Systems
- Task 7: Installing & Configuring GC-100 Network Adapters
- Task 8: Installing Set-Top Boxes
- Task 9: Installing & Configuring Allégro Systems
- Task 10: Verification & Readiness Check
- Task 11: Managing the iControl Edge Configuration Files
- Task 12: Uploading and Applying iControl Edge Configuration Files
- Key Concepts
- Troubleshooting
- Installing PuTTY
- Using WinSCP
- Contact Us!
Installation and Setup
Installing & Configuring Densité Systems
54
2. Click EdgeVision Configurator.
EdgeVision Configurator opens.
Task 6: Installing & Configuring Densité Systems
Densité modules housed in your Densité frames process video and audio signals from set-
top boxes and relay monitoring data and alarms to the iControl Edge Application Server.
IMPORTANT: Perform this task only if you are NOT installing an EdgeVision for the purposes of
probing signals.