Setup guide
Table Of Contents
- Introduction to iControl Edge
- System Requirements
- Installation and Setup
- Key Concepts
- Task 1: Preparing to Install an iControl Edge System
- Task 2: Installing the iControl Application Server
- Task 3: Preparing a PC for Configuring the Application Server
- Task 4: Configuring the Application Server
- Task 5: Installing & Configuring EdgeVision Devices
- Task 6: Installing & Configuring Densité Systems
- Task 7: Installing & Configuring GC-100 Network Adapters
- Task 8: Installing Set-Top Boxes
- Task 9: Installing & Configuring Allégro Systems
- Task 10: Verification & Readiness Check
- Task 11: Managing the iControl Edge Configuration Files
- Task 12: Uploading and Applying iControl Edge Configuration Files
- Key Concepts
- Troubleshooting
- Installing PuTTY
- Using WinSCP
- Contact Us!
iControl Edge
Installation and Setup Guide
53
6. To enable the Video/audio probing option, click Enable next to the Video/audio probing
option field and enter the option key provided by Miranda Technologies Inc.
Launching EdgeVision Configurator
To be able to configure the alarms and flags on your device, you must connect to the device
using the Management port IP address. You will not be able to launch EdgeVision Configurator
using the Data port IP address.
To launch EdgeVision Configurator
1. Launch the EdgeVision page in a Web browser (using the device’s Management IP address).
The EdgeVision home page appears.
Input status fields
Input status field Definition
Analog audio device power down
status
For debug purposes only.
Analog video device power down
status
Digital audio device power down
status
Firmware major version
Firmware minor version
FPGA major version
FPGA minor version
HDMI device power down status
SDI device power down status
Video presence Displays the the format detected on the input (ex. SDI-
525).
See also
For more information about the IP address of the Management port, see "Defining the
Network Parameters", on page 46.