Setup guide
Table Of Contents
- Introduction to iControl Edge
- System Requirements
- Installation and Setup
- Key Concepts
- Task 1: Preparing to Install an iControl Edge System
- Task 2: Installing the iControl Application Server
- Task 3: Preparing a PC for Configuring the Application Server
- Task 4: Configuring the Application Server
- Task 5: Installing & Configuring EdgeVision Devices
- Task 6: Installing & Configuring Densité Systems
- Task 7: Installing & Configuring GC-100 Network Adapters
- Task 8: Installing Set-Top Boxes
- Task 9: Installing & Configuring Allégro Systems
- Task 10: Verification & Readiness Check
- Task 11: Managing the iControl Edge Configuration Files
- Task 12: Uploading and Applying iControl Edge Configuration Files
- Key Concepts
- Troubleshooting
- Installing PuTTY
- Using WinSCP
- Contact Us!
iControl Edge
Installation and Setup Guide
51
Detail of drop-down panels on Status and options page
3. Click the Status and options link.
A set of drop-down panels appears for the device and the Inputs that reside in it. You can
hide or display these panels using the Toggle button. These panels include:
4. You can view the system status by clicking the Toggle button to open the Health panel. The
following system status fields appears:
Note: If you clicked another link and do not see the above panels, you can click the
Status and options link to display them.
Status and Options Panels
Panel Definition
Device Displays the type of device that is currently active at the IP address, followed by its serial number.
The device types include the following:
• EdgeVision-1/EdgeVision-2/EdgeVision-4
• EdgeVision-1 SDI/EdgeVision-2 SDI/EdgeVision-4 SDI
You can reboot the device by clicking Reset EdgeVision.
Health Displays the status and data about the chassis.
This panel appears when you open the Device panel.
Input # Displays status and data about the Inputs currently in the device. There is one of these panels for
each Input in the device.
This panel appears when you open the Device panel.
Restart device
Refresh fields Toggle panel
Restart Input