Setup guide
Table Of Contents
- Introduction to iControl Edge
- System Requirements
- Installation and Setup
- Key Concepts
- Task 1: Preparing to Install an iControl Edge System
- Task 2: Installing the iControl Application Server
- Task 3: Preparing a PC for Configuring the Application Server
- Task 4: Configuring the Application Server
- Task 5: Installing & Configuring EdgeVision Devices
- Task 6: Installing & Configuring Densité Systems
- Task 7: Installing & Configuring GC-100 Network Adapters
- Task 8: Installing Set-Top Boxes
- Task 9: Installing & Configuring Allégro Systems
- Task 10: Verification & Readiness Check
- Task 11: Managing the iControl Edge Configuration Files
- Task 12: Uploading and Applying iControl Edge Configuration Files
- Key Concepts
- Troubleshooting
- Installing PuTTY
- Using WinSCP
- Contact Us!
Installation and Setup
Viewing the Status and Configuring the Options
50
iControl Lookup Locations page (boxes for new entries for GSM locations list circled)
Viewing the Status and Configuring the Options
You can also use the EdgeVision Admin page to view the current status of the Inputs on the
current device, as well as configure the options on the Inputs.
To view the status of the Inputs
1. Using the device’s IP address, access the EdgeVision page in a Web browser.
The EdgeVision home page appears.
2. Click the EdgeVision Admin button.
The EdgeVision Admin page appears and displays the Status and options panels.
Status and options panels with drop-down panels circled in red