Setup guide
Table Of Contents
- Introduction to iControl Edge
- System Requirements
- Installation and Setup
- Key Concepts
- Task 1: Preparing to Install an iControl Edge System
- Task 2: Installing the iControl Application Server
- Task 3: Preparing a PC for Configuring the Application Server
- Task 4: Configuring the Application Server
- Task 5: Installing & Configuring EdgeVision Devices
- Task 6: Installing & Configuring Densité Systems
- Task 7: Installing & Configuring GC-100 Network Adapters
- Task 8: Installing Set-Top Boxes
- Task 9: Installing & Configuring Allégro Systems
- Task 10: Verification & Readiness Check
- Task 11: Managing the iControl Edge Configuration Files
- Task 12: Uploading and Applying iControl Edge Configuration Files
- Key Concepts
- Troubleshooting
- Installing PuTTY
- Using WinSCP
- Contact Us!
Installation and Setup
Defining the Network Parameters
46
Defining the Network Parameters
Before you can launch EdgeVision Configurator or EdgeVision Player, you need to define the
device’s network parameters using the EdgeVision Admin. These parameters include the
device’s system name, IP address, and the current date and time.
To be able to configure the network parameters for your device, you must connect to the device
using the Management port IP address. You will not be able to launch EdgeVision Admin using
the Data port IP address.
To define the system parameters
1. Launch the EdgeVision page in a Web browser (using the device’s Management port
IP address).
The EdgeVision home page appears.
2. Click EdgeVision Admin.
3. Click System Configuration.
Gray The feature is currently offline.
Black Alarm exists, but has been disabled at the source. Some devices have the
ability to deactivate certain alarms on the hardware itself, resulting in these
alarms appearing black.
LED Status Legend (
Conti nued
)
LED color Definition