Setup guide
Table Of Contents
- Introduction to iControl Edge
- System Requirements
- Installation and Setup
- Key Concepts
- Task 1: Preparing to Install an iControl Edge System
- Task 2: Installing the iControl Application Server
- Task 3: Preparing a PC for Configuring the Application Server
- Task 4: Configuring the Application Server
- Task 5: Installing & Configuring EdgeVision Devices
- Task 6: Installing & Configuring Densité Systems
- Task 7: Installing & Configuring GC-100 Network Adapters
- Task 8: Installing Set-Top Boxes
- Task 9: Installing & Configuring Allégro Systems
- Task 10: Verification & Readiness Check
- Task 11: Managing the iControl Edge Configuration Files
- Task 12: Uploading and Applying iControl Edge Configuration Files
- Key Concepts
- Troubleshooting
- Installing PuTTY
- Using WinSCP
- Contact Us!
Installation and Setup
Launching EdgeVision Admin
44
The EdgeVision Update Application appears.
3. Using the Browse button, select the file that contains the updated software (all EdgeVision
software files use a
.OS extension).
The selected file appears in the Source OS file field.
4. Type the IP address for the device that you wish to update in the IP address field.
The IP address for the current device appears in this field by default.
5. Click Upload when done.
Once you click upload, the file is uploaded and the device reboots itself automatically,
installing the software that you have selected.
6. If you are sure you are ready to continue, click Ye s .
Once the device reboots and the software has been updated, the EdgeVision Webpage
reloads. If any sessions of EdgeVision Configurator or EdgeVision Player are running, you
should shut them down and restart them.
Launching EdgeVision Admin
EdgeVision Admin is a Web page that connects directly to your EdgeVision device. Not only
does it display its current operational status, but it also allows you to configure its network
and device properties. These device properties also appear in EdgeVision Player and
EdgeVision Configurator.
To launch EdgeVision Admin
1. Launch the EdgeVision page in a Web browser (using the device’s Management IP address).
The EdgeVision home page appears.
Note: Before the file is uploaded to the device, the updater verifies that the file is in
the correct format. If the file is valid, the upload process begins. If the file is not valid,
the upload is halted and the following message appears at the bottom of the dialog
box:
ERROR:Inputfilehasincorrectformat
Note: While the upgrade is in progress, the EdgeVision device will stop its normal
operations and reboot in upgrade mode, which means that it will stop doing its
normal operations (e.g. no streaming, no IR control, etc.) until the upgrade is
completed. When the upgrade is complete, the device reboots again in normal
mode.