Setup guide
Table Of Contents
- Introduction to iControl Edge
- System Requirements
- Installation and Setup
- Key Concepts
- Task 1: Preparing to Install an iControl Edge System
- Task 2: Installing the iControl Application Server
- Task 3: Preparing a PC for Configuring the Application Server
- Task 4: Configuring the Application Server
- Task 5: Installing & Configuring EdgeVision Devices
- Task 6: Installing & Configuring Densité Systems
- Task 7: Installing & Configuring GC-100 Network Adapters
- Task 8: Installing Set-Top Boxes
- Task 9: Installing & Configuring Allégro Systems
- Task 10: Verification & Readiness Check
- Task 11: Managing the iControl Edge Configuration Files
- Task 12: Uploading and Applying iControl Edge Configuration Files
- Key Concepts
- Troubleshooting
- Installing PuTTY
- Using WinSCP
- Contact Us!
iControl Edge
Installation and Setup Guide
43
Updating the Software
You can update the EdgeVision device’s software using the EdgeVision home page. The
software updates the device’s operating system. The current version of the EdgeVision device
appears in Firmware major/minor fields in the EdgeVision Admin page (see "Viewing the
Status and Configuring the Options", on page 50).
When you update the software, only the software is changed. Any configuration changes you
made to the Network parameters using EdgeVision Admin are NOT lost when the software
is updated. If a software update is interrupted, you should reboot the device and restart the
software update.
To ensure that you have the latest software on your device, please contact Miranda Technical
Support.
To upgrade the software on the EdgeVision device
1. Launch the EdgeVision page in a Web browser (using the IP address for the Management
port).
The EdgeVision home page appears.
2. Click the EdgeVision link at the bottom of the page. Accept to open the
.jnlp file.
SDI Connector Not supplied
HDMI Optional (2m)
S/PDIF Optional (3m)
Note: To perform the update, you must use the IP address for the Management port
only. If you connect to the device using the IP address for the Data port, the update
will be halted and the following error message will appear:
ERROR:MustuseManagementIP addresstodoupgrade
Connector cables and plugs (
Conti nued
)
Cable Connector Type Input Plug Standard/Optional