Setup guide
Table Of Contents
- Introduction to iControl Edge
- System Requirements
- Installation and Setup
- Key Concepts
- Task 1: Preparing to Install an iControl Edge System
- Task 2: Installing the iControl Application Server
- Task 3: Preparing a PC for Configuring the Application Server
- Task 4: Configuring the Application Server
- Task 5: Installing & Configuring EdgeVision Devices
- Task 6: Installing & Configuring Densité Systems
- Task 7: Installing & Configuring GC-100 Network Adapters
- Task 8: Installing Set-Top Boxes
- Task 9: Installing & Configuring Allégro Systems
- Task 10: Verification & Readiness Check
- Task 11: Managing the iControl Edge Configuration Files
- Task 12: Uploading and Applying iControl Edge Configuration Files
- Key Concepts
- Troubleshooting
- Installing PuTTY
- Using WinSCP
- Contact Us!
Installation and Setup
Connecting the Cables to the EdgeVision Device
42
Connecting the Cables to the EdgeVision Device
The following cables can be attached to the EdgeVision device.
6.
View status and configure options (see page 50.
7.
Using the EdgeVision Configurator, configure how the feeds connect to the inputs and
define the Streaming parameters (including to which interface (MGMT or DATA) the streams
are to be sent). You can also select which alarms to use to monitor the feed and what
triggers them (see "Launching EdgeVision Configurator", on page 53).
8.
Access EdgeVision Player to monitor up to four feeds from the EdgeVision device (see the
EdgeVision User Guide).
Connector cables and plugs
Cable Connector Type Input Plug Standard/Optional
Three-prong C-13
power cord
Standard
CVBS cable
Right/Left audio
cables
Standard (3m)
RCA Standard (2m)
Infrared Standard (2m including
the adhesive adaptor)
RJ-45 Not supplied
EdgeVision Installation Workflow (
Conti nued
)