Setup guide
Table Of Contents
- Introduction to iControl Edge
- System Requirements
- Installation and Setup
- Key Concepts
- Task 1: Preparing to Install an iControl Edge System
- Task 2: Installing the iControl Application Server
- Task 3: Preparing a PC for Configuring the Application Server
- Task 4: Configuring the Application Server
- Task 5: Installing & Configuring EdgeVision Devices
- Task 6: Installing & Configuring Densité Systems
- Task 7: Installing & Configuring GC-100 Network Adapters
- Task 8: Installing Set-Top Boxes
- Task 9: Installing & Configuring Allégro Systems
- Task 10: Verification & Readiness Check
- Task 11: Managing the iControl Edge Configuration Files
- Task 12: Uploading and Applying iControl Edge Configuration Files
- Key Concepts
- Troubleshooting
- Installing PuTTY
- Using WinSCP
- Contact Us!
iControl Edge
Installation and Setup Guide
39
Restarting the System and Verifying the Configuration
Once you have specified all the settings your Application Server needs to be able to operate
on your local network, you must restart the system to apply the new configuration.
To restart the system and verify the configuration
1. On the Webmin home page, click Bootup and Shutdown.
Notes
•Clicking Save does not update the Application Server with the new
configuration. To apply your changes, you still need to click Apply
Configuration on the Network Configuration page or restart the system
through Webmin (see "Restarting the System and Verifying the
Configuration", on page 39).
• The Application Server’s eth0 port is set to auto-negotiate, full duplex mode
by default. This setting should not be changed. The network switch to which
the Application Server is connected should also be set to auto-negotiate to
avoid data packet loss.
REQUIREMENTS
Make sure you meet the following conditions before beginning this procedure:
• You are logged on to iControl Webmin (see "Logging on to Webmin", on page 30).
• You have performed step 2 through step 4, inclusive, of "Configuring the Network", on
page 32.