Setup guide
Table Of Contents
- Introduction to iControl Edge
- System Requirements
- Installation and Setup
- Key Concepts
- Task 1: Preparing to Install an iControl Edge System
- Task 2: Installing the iControl Application Server
- Task 3: Preparing a PC for Configuring the Application Server
- Task 4: Configuring the Application Server
- Task 5: Installing & Configuring EdgeVision Devices
- Task 6: Installing & Configuring Densité Systems
- Task 7: Installing & Configuring GC-100 Network Adapters
- Task 8: Installing Set-Top Boxes
- Task 9: Installing & Configuring Allégro Systems
- Task 10: Verification & Readiness Check
- Task 11: Managing the iControl Edge Configuration Files
- Task 12: Uploading and Applying iControl Edge Configuration Files
- Key Concepts
- Troubleshooting
- Installing PuTTY
- Using WinSCP
- Contact Us!
Installation and Setup
Specifying a Network Gateway
36
To specify a network gateway to be used by the Application Server
1. On the Network Configuration page, click Routing and Gateways.
The Routing and Gateways page appears.
2. Select eth0 from the Interface list in the Default routes area.
3. Ask your system administrator for the IP address of the network gateway that this
Application Server will use, and then type this address in the Gateway box. If a gateway is
not being used, then leave the Gateway box empty.
4. Click No beside Act as Router.
5. Leave the Static routes boxes blank.
6. In the Local routes boxes, do not change the value that appears for the eth0 interface
unless your system administrator advises it.
7. Click Save.
REQUIREMENT
Before beginning this procedure, make sure you have navigated to the Network
Configuration page of Webmin (see page 29).