Setup guide

iControl Edge
Installation and Setup Guide
35
2. Click the IP address of the Application Server (10.0.3.6 in the example screen shown
above).
The Edit Host Address page appears.
3. In the IP Address box, type the IP address you would like to give to this Application Server.
4. In the Hostnames box, make sure the listed host name is the correct one, and then (if
required) type one or more other names that will refer to this IP address.
5. Click Save.
The Host Addresses page reappears. The saved host names appear in the list.
6. Return to the Network Configuration page by clicking the Return arrow at the bottom of the
Host Addresses page.
Specifying a Network Gateway
In order for an Application Server to be able to send to (or receive data from) devices outside
its own subnet, it must use a network gateway.
Note: If the host name you entered on the Host Name and DNS Client page is not
accurately listed here, correct this name in the Edit Host Address page, now.
Note: Clicking Save does not update the Application Server with the new
configuration. To apply your changes, you still need to click Apply Configuration on
the Network Configuration page or restart the system through Webmin
(see "Restarting the System and Verifying the Configuration", on page 39).
Note: Do not click Apply Configuration on the Network Configuration page.