Setup guide
Table Of Contents
- Introduction to iControl Edge
- System Requirements
- Installation and Setup
- Key Concepts
- Task 1: Preparing to Install an iControl Edge System
- Task 2: Installing the iControl Application Server
- Task 3: Preparing a PC for Configuring the Application Server
- Task 4: Configuring the Application Server
- Task 5: Installing & Configuring EdgeVision Devices
- Task 6: Installing & Configuring Densité Systems
- Task 7: Installing & Configuring GC-100 Network Adapters
- Task 8: Installing Set-Top Boxes
- Task 9: Installing & Configuring Allégro Systems
- Task 10: Verification & Readiness Check
- Task 11: Managing the iControl Edge Configuration Files
- Task 12: Uploading and Applying iControl Edge Configuration Files
- Key Concepts
- Troubleshooting
- Installing PuTTY
- Using WinSCP
- Contact Us!
Installation and Setup
Configuring the Network
32
Configuring the Network
When configuring your network you must configure host addresses, DNS client, Gateway, and
network interfaces in the proper sequence.
To configure the network
1. Specify the DNS settings to be used by your Application Server (see "Specifying DNS Client
Settings", on page 33).
2. Configure your host addresses (see "Configuring Host Addresses", on page 34).
3. Specify a network gateway to be used by your Application Server (see "Specifying a
Network Gateway", on page 35).
4. Configure the Ethernet interface (see "Configuring the Ethernet Interface", on page 37).
5. Add any EdgeVision devices you intend to use to the Application Server Lookup Locations
list in iC Web.
6. Restart the system and verify the configuration (see "Restarting the System and Verifying
the Configuration", on page 39).