Setup guide
Table Of Contents
- Introduction to iControl Edge
- System Requirements
- Installation and Setup
- Key Concepts
- Task 1: Preparing to Install an iControl Edge System
- Task 2: Installing the iControl Application Server
- Task 3: Preparing a PC for Configuring the Application Server
- Task 4: Configuring the Application Server
- Task 5: Installing & Configuring EdgeVision Devices
- Task 6: Installing & Configuring Densité Systems
- Task 7: Installing & Configuring GC-100 Network Adapters
- Task 8: Installing Set-Top Boxes
- Task 9: Installing & Configuring Allégro Systems
- Task 10: Verification & Readiness Check
- Task 11: Managing the iControl Edge Configuration Files
- Task 12: Uploading and Applying iControl Edge Configuration Files
- Key Concepts
- Troubleshooting
- Installing PuTTY
- Using WinSCP
- Contact Us!
Installation and Setup
Installing Java
30
Installing Java
In the course of using iControl Edge, certain software modules (e.g. iC Web) may be
downloaded from the Application Server to your client PC or laptop. To run any of these
iControl applications, you must have the Java 2 Runtime Environment (JRE) installed on
your PC or laptop. The installer is available from the Application Server itself.
To install the Java 2 Runtime Environment on your PC or laptop
1. Click Useful downloads on the iControl Startup page.
2. Click JRE for Windows. When prompted, save the installer file (the file name should be
similar to
jre‐1_5_07‐windows‐i586‐p.exe).
3. Open the installer file.
The installation process takes several seconds.
Once completed, a confirmation message appears.
Logging on to Webmin
Webmin is the Application Server’s built-in Web management utility. Logging on to Webmin
is the starting point for accomplishing many tasks, including configuring the Application
Server.
To log on to the Webmin utility
1. Click System Tools on the iControl Startup page.
The System Tools page appears.
2. Click Administration.