Setup guide
Table Of Contents
- Introduction to iControl Edge
- System Requirements
- Installation and Setup
- Key Concepts
- Task 1: Preparing to Install an iControl Edge System
- Task 2: Installing the iControl Application Server
- Task 3: Preparing a PC for Configuring the Application Server
- Task 4: Configuring the Application Server
- Task 5: Installing & Configuring EdgeVision Devices
- Task 6: Installing & Configuring Densité Systems
- Task 7: Installing & Configuring GC-100 Network Adapters
- Task 8: Installing Set-Top Boxes
- Task 9: Installing & Configuring Allégro Systems
- Task 10: Verification & Readiness Check
- Task 11: Managing the iControl Edge Configuration Files
- Task 12: Uploading and Applying iControl Edge Configuration Files
- Key Concepts
- Troubleshooting
- Installing PuTTY
- Using WinSCP
- Contact Us!
Installation and Setup
Connecting to the Application Server
28
2. Open a browser window on the client PC or laptop.
3. In the address bar, type
10.0.3.6.
4. The iControl Startup Page appears.
Note: The default IP address and subnet mask settings for the Application Server
when shipped from the factory are shown on a sticker on the top cover of the chassis
above the front-panel power switch. The factory default is
10.0.3.6.
Note: The default IP address and subnet mask settings for the Application Server are
shown on a sticker on the top cover of the chassis.