Setup guide
Table Of Contents
- Introduction to iControl Edge
- System Requirements
- Installation and Setup
- Key Concepts
- Task 1: Preparing to Install an iControl Edge System
- Task 2: Installing the iControl Application Server
- Task 3: Preparing a PC for Configuring the Application Server
- Task 4: Configuring the Application Server
- Task 5: Installing & Configuring EdgeVision Devices
- Task 6: Installing & Configuring Densité Systems
- Task 7: Installing & Configuring GC-100 Network Adapters
- Task 8: Installing Set-Top Boxes
- Task 9: Installing & Configuring Allégro Systems
- Task 10: Verification & Readiness Check
- Task 11: Managing the iControl Edge Configuration Files
- Task 12: Uploading and Applying iControl Edge Configuration Files
- Key Concepts
- Troubleshooting
- Installing PuTTY
- Using WinSCP
- Contact Us!
Installation and Setup
Configuring the Application Server
26
Configuring TCP/IP settings on a PC running Windows XP.
6. Take note of the PC’s current settings.
7. The default IP address of each new iControl Application Server is
10.0.3.6. On the
client PC, type an address in the same range (e.g. 10.0.3.10) in the IP address field.
8. The default subnet mask of each new iControl Application Server is
255.255.0.0. On the
client PC, type 255.255.0.0 in the Subnet mask field.
9. Click OK to apply these settings.
10. In the Local Area Connection Properties window, click OK.
11. Close the Network Connections control panel.
Task 4: Configuring the Application Server
A user can connect to the Application Server via TCP/IP from any convenient desktop or
portable computer. Before you can begin operations, you must configure the Application
Server and make it available on your local network. The following is one possible workflow
for configuring your Application Server:
Note: The default IP address and subnet mask settings for the Application Server are
usually shown on a sticker on the top cover of its chassis.
Note: Remember to return the PC to its original network settings once you have
finished configuring the iControl Application Server.