Setup guide
Table Of Contents
- Introduction to iControl Edge
- System Requirements
- Installation and Setup
- Key Concepts
- Task 1: Preparing to Install an iControl Edge System
- Task 2: Installing the iControl Application Server
- Task 3: Preparing a PC for Configuring the Application Server
- Task 4: Configuring the Application Server
- Task 5: Installing & Configuring EdgeVision Devices
- Task 6: Installing & Configuring Densité Systems
- Task 7: Installing & Configuring GC-100 Network Adapters
- Task 8: Installing Set-Top Boxes
- Task 9: Installing & Configuring Allégro Systems
- Task 10: Verification & Readiness Check
- Task 11: Managing the iControl Edge Configuration Files
- Task 12: Uploading and Applying iControl Edge Configuration Files
- Key Concepts
- Troubleshooting
- Installing PuTTY
- Using WinSCP
- Contact Us!
iControl Edge
Installation and Setup Guide
25
10. Click OK to apply these settings.
11. In the Local Area Connection Properties window, click OK.
12. Close the Network and Sharing Center control panel.
Configuring TCP/IP Settings of a Client PC Running Windows XP Professional
To configure TCP/IP settings of a client PC running Windows XP Professional
1. Open Windows Control Panel.
2. In Control Panel, click Network Connections.
3. Select the currently active Local Area Connection, and then right-click and click Properties.
4. In the Local Area Connection Properties window, select Internet Protocol (TCP/IP), and
then click Properties.
5. In the Internet Protocol (TCP/IP) Properties window, click Use the following IP address.
Note: Remember to return the PC to its original network settings once you have
finished configuring the iControl Application Server.