Setup guide
Table Of Contents
- Introduction to iControl Edge
- System Requirements
- Installation and Setup
- Key Concepts
- Task 1: Preparing to Install an iControl Edge System
- Task 2: Installing the iControl Application Server
- Task 3: Preparing a PC for Configuring the Application Server
- Task 4: Configuring the Application Server
- Task 5: Installing & Configuring EdgeVision Devices
- Task 6: Installing & Configuring Densité Systems
- Task 7: Installing & Configuring GC-100 Network Adapters
- Task 8: Installing Set-Top Boxes
- Task 9: Installing & Configuring Allégro Systems
- Task 10: Verification & Readiness Check
- Task 11: Managing the iControl Edge Configuration Files
- Task 12: Uploading and Applying iControl Edge Configuration Files
- Key Concepts
- Troubleshooting
- Installing PuTTY
- Using WinSCP
- Contact Us!
Installation and Setup
Configuring TCP/IP Settings of a Client PC Running Windows 7
24
5. Select Internet Protocol Version 4 (TCP/IPv4), and then click Properties.
The Internet Protocol Version 4 (TCP/IPv4) Properties window appears.
6. Take note of the PC’s current settings.
7. Click Use the following IP address.
8. The default IP address of each new iControl Application Server is
10.0.3.6. On the
client PC, type an address in the same range (e.g. 10.0.3.10) in the IP address field.
9. The default subnet mask of each new iControl Application Server is
255.255.0.0. On the
client PC, type
255.255.0.0 in the Subnet mask field.
Note: The default IP address and subnet mask settings for the Application Server are
usually shown on a sticker on the top cover of its chassis.