Setup guide
Table Of Contents
- Introduction to iControl Edge
- System Requirements
- Installation and Setup
- Key Concepts
- Task 1: Preparing to Install an iControl Edge System
- Task 2: Installing the iControl Application Server
- Task 3: Preparing a PC for Configuring the Application Server
- Task 4: Configuring the Application Server
- Task 5: Installing & Configuring EdgeVision Devices
- Task 6: Installing & Configuring Densité Systems
- Task 7: Installing & Configuring GC-100 Network Adapters
- Task 8: Installing Set-Top Boxes
- Task 9: Installing & Configuring Allégro Systems
- Task 10: Verification & Readiness Check
- Task 11: Managing the iControl Edge Configuration Files
- Task 12: Uploading and Applying iControl Edge Configuration Files
- Key Concepts
- Troubleshooting
- Installing PuTTY
- Using WinSCP
- Contact Us!
Installation and Setup
Preparing a PC for Configuring the Application Server
22
Task 3: Preparing a PC for Configuring the Application Server
You will use a client PC to configure the new Application Server. The client PC must have
network settings that will allow it to communicate with an iControl Application Server in its
default state.
Perform one of the following procedures depending upon your client PC’s operating system:
• "Configuring TCP/IP Settings of a Client PC Running Windows 7", on page 22
• "Configuring TCP/IP Settings of a Client PC Running Windows XP Professional", on page 25
Configuring TCP/IP Settings of a Client PC Running Windows 7
To configure TCP/IP settings of a client PC running Windows 7
1. From the Windows 7 Start menu, click Control Panel.
The Control Panel appears.
2. Click Network and Sharing Center.
The Network and Sharing Center appears.
3. In the Access type area, click the link that corresponds to your LAN Internet connection
(Local Area Connection in the example shown).