Setup guide

Installation and Setup
Preparing to Install an iControl Edge System
20
 Four rubber pads (when used as a table-top device)
 AC secure wire clips
If applicable, make sure the following items have been shipped with your GC-100 network
adapters:
 Global Caché GC-100 network adapters (one for each set of 6 set-top boxes to be
controlled)
 One AC power supply unit and AC cord
 Six IR emitter cables
 Six stick-on shields
If applicable, make sure the following items have been shipped with your Densité frames:
 Densité housing frame with one controller card
 The Densité series devices you ordered
 One ADC-800 CAM HDV camera HD/SD A-to-D converter, for each HCP-1801 module you
ordered
 Blank rear panels (for empty slots)
 One AC power supply unit and AC cord
 A second power supply and AC cord (optional)
If applicable, make sure the following items have been shipped with your Allégro systems:
 Allégro unit
 Rack mounting kit (rails, screws and washers)
 AC power cord
Once the hardware components are all in place, each device must be configured to work on
a common TCP/IP network. Other operational parameters, such as which alarm conditions are
to be monitored, should also be configured.
--- Video probes --- --- Audio probes ---
VCP-1021 Composite Video Control Probe ACP-1721 Digital Audio Control Probe
--- or any of the following --- --- with any of the following ---
• DEC-1002 10-Bit Composite to SDI Decoder
• DEC-1003 10-Bit Composite to SDI Decoder
• DEC-1021 12-Bit Composite to SDI Decoder
• DEC-1023 12-Bit Composite to SDI Decoder
• UAP-1781 Eight-Channel Universal Audio Processor
• UAP-1783 Eight-Channel Universal Audio Processor
• AAP-1741 Four-Channel Analog Audio Processor
--- or the following probe --- --- with the following converter ---
HCP-1801HD/SD SDI Control Probe ADC-800 CAM
HDV Camera HD/SD A-to-D Converter