Setup guide
Table Of Contents
- Introduction to iControl Edge
- System Requirements
- Installation and Setup
- Key Concepts
- Task 1: Preparing to Install an iControl Edge System
- Task 2: Installing the iControl Application Server
- Task 3: Preparing a PC for Configuring the Application Server
- Task 4: Configuring the Application Server
- Task 5: Installing & Configuring EdgeVision Devices
- Task 6: Installing & Configuring Densité Systems
- Task 7: Installing & Configuring GC-100 Network Adapters
- Task 8: Installing Set-Top Boxes
- Task 9: Installing & Configuring Allégro Systems
- Task 10: Verification & Readiness Check
- Task 11: Managing the iControl Edge Configuration Files
- Task 12: Uploading and Applying iControl Edge Configuration Files
- Key Concepts
- Troubleshooting
- Installing PuTTY
- Using WinSCP
- Contact Us!
iControl Edge
Installation and Setup Guide
13
Allégro-1 Analog
--- SETUP 6 ---
Application Server
EdgeVision device
Densité frame
GC-100 network adapter
Allégro-1 Analog
--- SETUP 7 ---
Application Server
EdgeVision device
Densité frame
GC-100 network adapter
Allégro-1 Analog
--- SETUP 8 ---
Application Server
EdgeVision device
Densité frame
GC-100 network adapter
Allégro-1 Analog
--- SETUP 9 ---
Application Server
EdgeVision device
Densité frame
GC-100 network adapter
Allégro-1 Analog
--- SETUP 10 ---
Application Server
EdgeVision device
Densité frame
Table 2-2: Your network settings (
Conti nued
)
Device IP Address Subnet Mask Gateway