Setup guide
Table Of Contents
- Introduction to iControl Edge
- System Requirements
- Installation and Setup
- Key Concepts
- Task 1: Preparing to Install an iControl Edge System
- Task 2: Installing the iControl Application Server
- Task 3: Preparing a PC for Configuring the Application Server
- Task 4: Configuring the Application Server
- Task 5: Installing & Configuring EdgeVision Devices
- Task 6: Installing & Configuring Densité Systems
- Task 7: Installing & Configuring GC-100 Network Adapters
- Task 8: Installing Set-Top Boxes
- Task 9: Installing & Configuring Allégro Systems
- Task 10: Verification & Readiness Check
- Task 11: Managing the iControl Edge Configuration Files
- Task 12: Uploading and Applying iControl Edge Configuration Files
- Key Concepts
- Troubleshooting
- Installing PuTTY
- Using WinSCP
- Contact Us!
Using WinSCP
Logging on to an Application Server from WinSCP
130
3. Click Login.
A message concerning the server’s host key may appear.
4. Click Ye s to continue.
The main WinSCP window appears, showing the files on your PC in the left panel, and the
files on the Application Server in the right panel.
Notes
• The default logon accounts are:
• default IP address:
10.0.3.6
• default user name: miranda, root
• default password (for both miranda and root): icontrol
•The miranda and root accounts both have suitable permissions for
most applications. However, for some specific purposes such as
configuring streaming relays for an Allégro (see "Configuring Allégro
Streaming Relays", on page 73), you will need to be logged on as user
root.