Setup guide
Table Of Contents
- Introduction to iControl Edge
- System Requirements
- Installation and Setup
- Key Concepts
- Task 1: Preparing to Install an iControl Edge System
- Task 2: Installing the iControl Application Server
- Task 3: Preparing a PC for Configuring the Application Server
- Task 4: Configuring the Application Server
- Task 5: Installing & Configuring EdgeVision Devices
- Task 6: Installing & Configuring Densité Systems
- Task 7: Installing & Configuring GC-100 Network Adapters
- Task 8: Installing Set-Top Boxes
- Task 9: Installing & Configuring Allégro Systems
- Task 10: Verification & Readiness Check
- Task 11: Managing the iControl Edge Configuration Files
- Task 12: Uploading and Applying iControl Edge Configuration Files
- Key Concepts
- Troubleshooting
- Installing PuTTY
- Using WinSCP
- Contact Us!
iControl Edge
Installation and Setup Guide
123
2. In the Session panel, specify your Application Server’s IP address or host name, make sure
that SSH is the selected connection type, and then click Open.
A command line window appears, prompting you for a user name.
3. Type
miranda, and then press
Enter
.
4. When prompted for a password, type
icontrol, and then press
Enter
.
You are now connected to the Application Server.
Ending a PuTTY Session
To end the SSH session
•Type
exit, and then press
Enter
to close the PuTTY command line window.
Note: If the PuTTY Security Alert window appears, click Ye s to close it.
Note: Application Servers are configured by default with the user name
miranda and the password icontrol, but these may have been changed by
your system administrator.