Setup guide
Table Of Contents
- Introduction to iControl Edge
- System Requirements
- Installation and Setup
- Key Concepts
- Task 1: Preparing to Install an iControl Edge System
- Task 2: Installing the iControl Application Server
- Task 3: Preparing a PC for Configuring the Application Server
- Task 4: Configuring the Application Server
- Task 5: Installing & Configuring EdgeVision Devices
- Task 6: Installing & Configuring Densité Systems
- Task 7: Installing & Configuring GC-100 Network Adapters
- Task 8: Installing Set-Top Boxes
- Task 9: Installing & Configuring Allégro Systems
- Task 10: Verification & Readiness Check
- Task 11: Managing the iControl Edge Configuration Files
- Task 12: Uploading and Applying iControl Edge Configuration Files
- Key Concepts
- Troubleshooting
- Installing PuTTY
- Using WinSCP
- Contact Us!
Installing PuTTY
Establishing an SSH Connection with an Application Server
122
4. When prompted, save the file to your desktop, or some other location on your PC or laptop.
Establishing an SSH Connection with an Application Server
To establish an SSH connection with the Application Server
1. Browse to the PuTTY executable file on your PC or laptop, and then open it.
The PuTTY Configuration window appears.
Note: If Windows prompt you about the application’s signature, click Ye s .