Setup guide
Table Of Contents
- Introduction to iControl Edge
- System Requirements
- Installation and Setup
- Key Concepts
- Task 1: Preparing to Install an iControl Edge System
- Task 2: Installing the iControl Application Server
- Task 3: Preparing a PC for Configuring the Application Server
- Task 4: Configuring the Application Server
- Task 5: Installing & Configuring EdgeVision Devices
- Task 6: Installing & Configuring Densité Systems
- Task 7: Installing & Configuring GC-100 Network Adapters
- Task 8: Installing Set-Top Boxes
- Task 9: Installing & Configuring Allégro Systems
- Task 10: Verification & Readiness Check
- Task 11: Managing the iControl Edge Configuration Files
- Task 12: Uploading and Applying iControl Edge Configuration Files
- Key Concepts
- Troubleshooting
- Installing PuTTY
- Using WinSCP
- Contact Us!
Installation and Setup
Launching the iControl Edge Web Site
118
iControl Edge single-screen Web page in full screen mode.
10. If you set this site as your home page, you will not need to go through the selection steps
described above any more.
The next time you open iControl Web, this iControl Edge Web page will appear by default.
Congratulations—your iControl Edge system is now ready for operation! For a more
complete description of the monitoring application, please refer to the iControl Edge
Operator’s Overview.
Note: To set this site to open by default, click Set home page on the To ol s menu.