Setup guide
Table Of Contents
- Introduction to iControl Edge
- System Requirements
- Installation and Setup
- Key Concepts
- Task 1: Preparing to Install an iControl Edge System
- Task 2: Installing the iControl Application Server
- Task 3: Preparing a PC for Configuring the Application Server
- Task 4: Configuring the Application Server
- Task 5: Installing & Configuring EdgeVision Devices
- Task 6: Installing & Configuring Densité Systems
- Task 7: Installing & Configuring GC-100 Network Adapters
- Task 8: Installing Set-Top Boxes
- Task 9: Installing & Configuring Allégro Systems
- Task 10: Verification & Readiness Check
- Task 11: Managing the iControl Edge Configuration Files
- Task 12: Uploading and Applying iControl Edge Configuration Files
- Key Concepts
- Troubleshooting
- Installing PuTTY
- Using WinSCP
- Contact Us!
iControl Edge
Installation and Setup Guide
113
To launch the iControl Edge Web site
1. From a client PC or laptop on the same network as the Application Server, open a Web
browser and type the Application Server’s IP address in the address bar.
The iControl Startup Page appears.
2. Click iC Web.
The Java Web Start window opens, and the iControl Web application is downloaded to
your PC or laptop. When the download is completed, the iControl Web splash screen
appears.
Note: The iControl Edge Web site can be accessed from any PC or laptop on the same
network as the Application Server. iControl Edge offers several pre-configured
versions of its main Web page. Choose either a dual-screen or a single-screen layout,
with the appropriate resolution for your client PC or laptop.