Setup guide
Table Of Contents
- Introduction to iControl Edge
- System Requirements
- Installation and Setup
- Key Concepts
- Task 1: Preparing to Install an iControl Edge System
- Task 2: Installing the iControl Application Server
- Task 3: Preparing a PC for Configuring the Application Server
- Task 4: Configuring the Application Server
- Task 5: Installing & Configuring EdgeVision Devices
- Task 6: Installing & Configuring Densité Systems
- Task 7: Installing & Configuring GC-100 Network Adapters
- Task 8: Installing Set-Top Boxes
- Task 9: Installing & Configuring Allégro Systems
- Task 10: Verification & Readiness Check
- Task 11: Managing the iControl Edge Configuration Files
- Task 12: Uploading and Applying iControl Edge Configuration Files
- Key Concepts
- Troubleshooting
- Installing PuTTY
- Using WinSCP
- Contact Us!
Installation and Setup
Launching the iControl Edge Web Site
112
The Miranda Monitoring page appears.
4. In the Start/Stop/Restart column, select Restart, for all General Status Manager (GSM)
services listed on the page, and then click Apply at the bottom of the page.
You have successfully restarted the GSM services and applied the settings contained in your
modified Configuration Spreadsheets.
Launching the iControl Edge Web Site
The iControl Edge system is designed to be ready for operation from the moment the initial
setup is completed. When the Application Server at the central monitoring location, and all
remote Application Servers, Densité frames, GC-100 network adapters and Allégro systems are
configured and online, an operator with network access can get started simply by launching
the iControl Edge Web site.
b. Click Apply
a. Select Restart