Setup guide
Table Of Contents
- Introduction to iControl Edge
- System Requirements
- Installation and Setup
- Key Concepts
- Task 1: Preparing to Install an iControl Edge System
- Task 2: Installing the iControl Application Server
- Task 3: Preparing a PC for Configuring the Application Server
- Task 4: Configuring the Application Server
- Task 5: Installing & Configuring EdgeVision Devices
- Task 6: Installing & Configuring Densité Systems
- Task 7: Installing & Configuring GC-100 Network Adapters
- Task 8: Installing Set-Top Boxes
- Task 9: Installing & Configuring Allégro Systems
- Task 10: Verification & Readiness Check
- Task 11: Managing the iControl Edge Configuration Files
- Task 12: Uploading and Applying iControl Edge Configuration Files
- Key Concepts
- Troubleshooting
- Installing PuTTY
- Using WinSCP
- Contact Us!
iControl Edge
Installation and Setup Guide
111
3. Close WinSCP.
You have successfully uploaded your modified configuration spreadsheets.
Restarting the General Status Manager (GSM) Services
Once you have uploaded the modified iControl Edge Configuration Spreadsheets, you must
restart iControl’s General Status Manager (GSM) services, and refresh the iControl Edge Web
page for the changes to take effect.
To restart iControl’s GSM services
1. Log on to Webmin (see "Logging on to Webmin", on page 30).
2. Click Miranda iControl Management Tool.
The Miranda Setup page appears.
3. Click the iControl logo next to iControl services monitoring and configuration tool.